JBraun Posted April 19, 2020 Report Share Posted April 19, 2020 Hi Foks, I'm trying to get my SYNC-3 system (2019) working on a bench, I connect pin number 1 to 12 volt, pin number 39 to GND, and from some reason the current consumption gets really high - as if something gets shortened. I have two similar systems - both have the same thing. Has anyone encountered this? Does anyone have a clue what should I do? Any help would be greatly appreciated, Jake. Quote Link to comment Share on other sites More sharing options...
jimbojambojumbo Posted May 8, 2020 Report Share Posted May 8, 2020 you can not just power it up you need can-bus signals to be sent so you need to put an arduino into the circuit with sheild Quote Link to comment Share on other sites More sharing options...
Chiggins Posted August 24, 2020 Report Share Posted August 24, 2020 On 5/7/2020 at 7:52 PM, jimbojambojumbo said: you can not just power it up you need can-bus signals to be sent so you need to put an arduino into the circuit with sheild Do you know what exact signals need to be sent? I an Arduino that I can send CAN-BUS messages with, I just need to know the messages. Quote Link to comment Share on other sites More sharing options...
Multitask Posted August 26, 2020 Report Share Posted August 26, 2020 Not sure if your answer is here... http://www.2gfusions.net/showthread.php?tid=12063 Might get better results here... They are more technical there... ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.