Jump to content
  • Welcome!

    Welcome to the Ford SYNC Forum!  Please sign in here or create an account here.



JBraun

Sync 3 Bench Test

Recommended Posts

Hi Foks,

 

I'm trying to get my SYNC-3 system (2019) working on a bench,

I connect pin number 1 to 12 volt, pin number 39 to GND, and from some reason the current consumption gets really high - as if something gets shortened.

I have two similar systems - both have the same thing.

 

Has anyone encountered this?

Does anyone have a clue what should I do?

 

Any help would be greatly appreciated,

Jake. 

 

 

Share this post


Link to post
Share on other sites

you can not just power it up you need can-bus signals to be sent so you need to put an arduino into the circuit with sheild

Share this post


Link to post
Share on other sites
On 5/7/2020 at 7:52 PM, jimbojambojumbo said:

you can not just power it up you need can-bus signals to be sent so you need to put an arduino into the circuit with sheild

 

Do you know what exact signals need to be sent? I an Arduino that I can send CAN-BUS messages with, I just need to know the messages.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Custom Search

×